![]() In the end I decided to leave it, since a far more convenient method for saving patches would be to put in the coin cell battery it was supposed to have. The mod involved clipping out a resistor and diode near the power supply and soldering wires onto the legs that are still protruding from the board. I used a coin battery holder so it could be replaced easily down the line, and some double-sided tape and Velcro to hold it down. A flatter holder would probably be better but this was what I had, and there seemed to be enough clearance there at the back of the synth for it. ![]() I closed the synth up, left it off for a few hours, powered it back on, and my presets were still intact.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |